An Improved Active Damping Method with Capacitor Current Feedback

Proportional capacitor current feedback active damping (CCFAD) has a limited valid damping region in the discrete time domain as (0, fs/6). However, the resonance frequency (fr) of an LCL-type filter is usually designed to be less than half the sampling frequency (fs) with the symmetry regular sampling method. Therefore, (fs/6, fs/2) becomes an invalid damping region. This paper proposes an improved CCFAD method to extend the valid damping region from (0, fs/6) to (0, fs/2), which covers all of the possible resonance frequencies in the design procedure. The full-valid damping region is obtained and the stability margin of the system is analyzed in the discrete time domain with the Nyquist criterion. Results show that the system can operate stably with the proposed CCFAD method when the resonance frequency is in the region (0, fs/2). The performances at the steady and dynamic state are enhanced by the selected feedback coefficient H and controller gain Kp. Finally, the feasibility and effectiveness of the proposed CCFAD method are verified by simulation and experimental results.

Statistics

Show / Hide Statistics

Cumulative Counts from September 30th, 2019
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.

Cite this article

[IEEE Style]

Y. Geng, Y. Qi, H. Liu, F. Guo, P. Zheng, Y. Li, W. Dong, "An Improved Active Damping Method with Capacitor Current Feedback," Journal of Power Electronics, vol. 18, no. 2, pp. 511-521, 2018. DOI: 10.6113/JPE.2018.18.2.511.

[ACM Style]

Yi-Wen Geng, Ya-Wen Qi, Hai-Wei Liu, Fei Guo, Peng-Fei Zheng, Yong-Gang Li, and Wen-Ming Dong. 2018. An Improved Active Damping Method with Capacitor Current Feedback. Journal of Power Electronics, 18, 2, (2018), 511-521. DOI: 10.6113/JPE.2018.18.2.511.