A Novel PCCM Voltage-Fed Single-Stage Power Factor Correction Full-Bridge Battery Charger


Vol. 16, No. 3, pp. 872-882, May  2016
10.6113/JPE.2016.16.3.872


PDF    

 Abstract

A novel pseudo-continuous conduction mode (PCCM) voltage-fed single-stage power factor correction (PFC) full-bridge battery charger is proposed in this paper. By connecting a freewheeling transistor in parallel with an input inductor, the PFC cell can operate in the PCCM with a constant duty ratio. Thus, the dc/dc stage can be designed using this constant duty ratio and the restriction on the duty ratio of the PFC cell is eliminated. As a result, the input current distortion is less and the dc bus voltage becomes controllable over the wide output power range of the battery charger. Moreover, the operation principle of the dc/dc stage is designed to be similar to that of a conventional phase-shifted full-bridge converter. Therefore, it is easy to implement. In this paper, the operation of the new converter is explained, and the design considerations of the controller and key parameters are presented. Simulation and experimental results obtained from a 1 kW prototype are given to confirm the operation of the proposed converter.


 Statistics
Show / Hide Statistics

Cumulative Counts from September 30th, 2019
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.



Cite this article

[IEEE Style]

T. Zhang, Z. Lu, Q. Qian, W. Sun, S. Lu, "A Novel PCCM Voltage-Fed Single-Stage Power Factor Correction Full-Bridge Battery Charger," Journal of Power Electronics, vol. 16, no. 3, pp. 872-882, 2016. DOI: 10.6113/JPE.2016.16.3.872.

[ACM Style]

Taizhi Zhang, Zhipeng Lu, Qinsong Qian, Weifeng Sun, and Shengli Lu. 2016. A Novel PCCM Voltage-Fed Single-Stage Power Factor Correction Full-Bridge Battery Charger. Journal of Power Electronics, 16, 3, (2016), 872-882. DOI: 10.6113/JPE.2016.16.3.872.