Application of a C-Type Filter Based LCFL Output Filter to Shunt Active Power Filters


Vol. 13, No. 6, pp. 1058-1069, Nov. 2013
10.6113/JPE.2013.13.6.1058


PDF    

 Abstract

This paper proposes and designs a new output filter called an LCFL filter for application to three phase three wire shunt active power filters (SAPF). This LCFL filter is derived from a traditional LCL filter by replacing its capacitor with a C-type filter, and then constructing an L-C-type Filter-L (LCFL) topology. The LCFL filter can provide better switching ripple attenuation capability than traditional passive damped LCL filters. The LC branch series resonant frequency of the LCFL filter is set at the switching frequency, which can bypass most of the switching harmonic current generated by a SAPF converter. As a result, the power losses in the damping resistor of the LCFL filter can be reduced when compared to traditional passive damped LCL filters. The principle and parameter design of the LCFL filter are presented in this paper, as well as a comparison to traditional passive damped LCL filters. Simulation and experimental results are presented to validate the theoretical analyses and effectiveness of the LCFL filter.


 Statistics
Show / Hide Statistics

Cumulative Counts from September 30th, 2019
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.



Cite this article

[IEEE Style]

C. Liu, K. Dai, K. Duan, Y. Kang, "Application of a C-Type Filter Based LCFL Output Filter to Shunt Active Power Filters," Journal of Power Electronics, vol. 13, no. 6, pp. 1058-1069, 2013. DOI: 10.6113/JPE.2013.13.6.1058.

[ACM Style]

Cong Liu, Ke Dai, Kewei Duan, and Yong Kang. 2013. Application of a C-Type Filter Based LCFL Output Filter to Shunt Active Power Filters. Journal of Power Electronics, 13, 6, (2013), 1058-1069. DOI: 10.6113/JPE.2013.13.6.1058.