A Comparative Study of Two Diagnostic Methods Based on the Switching Voltage Pattern for IGBT Open-Circuit Faults in Voltage-Source Inverters


Vol. 16, No. 3, pp. 1087-1096, May  2016
10.6113/JPE.2016.16.3.1087


PDF    

 Abstract

This paper reports an investigation conducted on two diagnostic methods based on the switching voltage pattern of IGBT open-circuit faults in voltage-source inverters (VSIs). One method was based on the bridge arm pole voltage, and the other was based on bridge arm line voltage. With an additional simple circuit, these two diagnostic methods detected and effectively identified single and multiple open-circuit faults of inverter IGBTs. A comparison of the times for the diagnosis and anti-interference features between these two methods is presented. The diagnostic time of both methods was less than 280ns in the best case. The diagnostic time for the method based on the bridge arm pole voltage was less than that of the method based on the bridge arm line voltage and was 1/2 of the fundamental period in the worst case. An experimental study was carried out to show the effectiveness of and the differences between these two methods.


 Statistics
Show / Hide Statistics

Cumulative Counts from September 30th, 2019
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.



Cite this article

[IEEE Style]

Y. Wang, Z. Li, M. Xu, H. Ma, "A Comparative Study of Two Diagnostic Methods Based on the Switching Voltage Pattern for IGBT Open-Circuit Faults in Voltage-Source Inverters," Journal of Power Electronics, vol. 16, no. 3, pp. 1087-1096, 2016. DOI: 10.6113/JPE.2016.16.3.1087.

[ACM Style]

Yuxi Wang, Zhan Li, Minghui Xu, and Hao Ma. 2016. A Comparative Study of Two Diagnostic Methods Based on the Switching Voltage Pattern for IGBT Open-Circuit Faults in Voltage-Source Inverters. Journal of Power Electronics, 16, 3, (2016), 1087-1096. DOI: 10.6113/JPE.2016.16.3.1087.