An Interference Isolation Method for Wireless Power and Signal Parallel Transmissions on CPT Systems

A novel interference isolation method is proposed by using several designed coils in capacitive power transfer systems as isolation impedances. For each designed coil, its stray parameters such as the inter-turn capacitance, coil resistance and capacitance between the coil and the core, etc. are taken into account. An equivalent circuit model of the designed coil is established. According to this equivalent circuit, the impedance characteristic of the coil is calculated. In addition, the maximum impedance point and the corresponding excitation frequency of the coil are obtained. Based on this analysis, six designed coils are adopted to isolate the interference from power delivery. The proposed method is verified through experiments with a power carrier frequency of 1MHz and a data carrier frequency of 8.7MHz. The power and data are transferred parrallelly with a data carrier attenuation lower than -5dB and a power attenuation on the sensing resistor higher than -45dB.

Statistics

Show / Hide Statistics

Cumulative Counts from September 30th, 2019
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.

Cite this article

[IEEE Style]

W. Zhou, Y. Su, S. Xie, L. Chen, X. Dai, Y. Zhao, "An Interference Isolation Method for Wireless Power and Signal Parallel Transmissions on CPT Systems," Journal of Power Electronics, vol. 17, no. 1, pp. 305-313, 2017. DOI: 10.6113/JPE.2019.17.1.305.

[ACM Style]

Wei Zhou, Yu-Gang Su, Shi-Yun Xie, Long Chen, Xin Dai, and Yu-Ming Zhao. 2017. An Interference Isolation Method for Wireless Power and Signal Parallel Transmissions on CPT Systems. Journal of Power Electronics, 17, 1, (2017), 305-313. DOI: 10.6113/JPE.2019.17.1.305.